Case studies – Page 5

▶ Industrial mesh

A cutting-edge matter

Cooling lubricant filtration without filter aid In addition to precise process design, the quality of the cooling lubricant is of vital importance to ensure the required minimum tolerances during knife production. Until now, Fortuna used a magnetic separator and a cyclone … ▶

▶ Industrial mesh

An all-round concept

Ready for the island Thanks to the positive experience with the MAXFLOW compact filter system the grinding specialist from Barchfeld is considering the acquisition of a second system. An isolated application providing greater flexibility for centre-less grinding with regards to … ▶

▶ Industrial mesh

MAXFLOW completely convinces a precision grinding company

Additional MAXFLOW unit in the planning As a result of the positive experience with the MAXFLOW system in the grinding shop in Wendelstein planning is already under way at Heinrich Müller GmbH to buy an additional MAXFLOW filter unit. “The long … ▶

▶ Industrial mesh

MAXFLOW passes the tool company test

Planned deployment as a central unit The decision as to which type of equipment will be used for cooling lubricant filtration during grinding of spiral grooves will be made in 2010. One thing is certain: the new filtration equipment in the grinding shop at Gühring … ▶

▶ Industrial mesh

Application comparison of the MAXFLOW compact filter system

MAXFLOW’s modularity demonstrates that retrofitting or adaptation to changing customer requirements are not a problem, even after installation. One of the modules in the MAXFLOW concept is a cooling system that leads off the heat generated … ▶

▶ Industrial mesh

Increase production – reduce costs

Optimistic prognosis Sascha Schönecken of GKD is optimistic: “The deployment of MAXFLOW at Paul Jores GmbH is very successful and has brought lots of advantages in terms of handling and costs.” Torsten Jores, Managing Director of Paul Jores GmbH, confirms … ▶

▶ Process belts

A strong solution for thermal bonding of thick insulation material

Strong hold The solution for the upper belt is a blended mesh construction of PPS and steel. This mesh type, called Duofil, with reinforced steel weft, was custom developed by GKD for the process at the Ziegler factory. One of its special … ▶

▶ Process belts

The fine art of nonwoven composites

“Unique on the market” Mondi Ascania had therefore been looking for quite some time for a belt that would provide full performance from the very start. At the INDEX 2014, they discussed the matter with GKD, a company well-known in the trade for its … ▶

▶ Industrial mesh

30 months in continuous operation and still no end in sight

Reducing maintenance costs and increasing process reliability: with these objectives in mind, ESIM Chemicals conducted a detailed analysis of the Funde filters they have been using for many years in their large-scale fumaric acid production. In … ▶

▶ Industrial mesh

LP-EGR filter with 3D mesh

Vehicle manufacturers and suppliers are working in close partnership to develop new solutions for reducing fuel consumption and thereby also CO2 emissions. Low-pressure exhaust gas recirculation (LP-EGR) systems are one example of how they are attempting to increase the … ▶